The most common item we sell are Bleacher Clips. Custom lengths are available please contact Tech Support for more information.We sell a lot of Aluminum Bleacher Planks, Boards, End Caps, Splices and Clips. They cannot be cut due to the steel rod that provides support for the splice joint. These sleeves come in two standard sizes of 40 mm and 60 mm. The clear outer tube of the splice protector sleeves allows the color of the optical fiber itself to be seen. The image to the right shows a properly heated splice protector sleeve in a fiber splicer (see Splice Sleeve Guide tab for more information). #Splice caps b connectors manualA fiber splicer can be used to ensure proper heating of the sleeve (refer to the operation manual of your splicer for correct heating settings). The bottom image shows insufficient heating here the shrink tube is not uniform across the splice, resulting in loose or poor protection for the splice joint. The middle image shows excessive heating here the shrink tube shows evidence of blemishes and melts in the tubing. The top image shows normal heating here the shrink tube is uniform across the splice, providing permanent and rigid protection. The image to the left illustrates the effects of proper and improper heating on these sleeves. Proper heating is required to ensure an accurate fit and function of the splice protector sleeve. The sleeve must then be heated causing the outer shrink tube to contract to Ø3.2 mm. Position the sleeve so that the splice joint is in the middle. To use, thread the fiber through the inner fiber tube of the sleeve. This design not only provides a replacement for the original fiber cable jacket, but also provides excellent rigidity around the splice joint, preventing the spliced area from bending or flexing. An outer shrink tube holds the tube through which the fiber is threaded as well as the strength member, a solid steel rod that provides rigid support for the splice joint. These fusion splice protector sleeves are an economic solution that offers reliable and solid protection for splice joints. Thorlabs' Splice Protector Sleeves are designed to protect splices in fibers with an outer diameter up to 900 µm. Available in Either 40 mm or 60 mm Lengths.For inquiries about custom splice-ready fibers, please contact Technical Support.Įffects of heating on splice protector sleeves. ![]() Alternatively, our Vytran ® fiber recoaters offer flexible, low-profile splice protection. Thorlabs offers fiber-to-fiber splices, fiber cleavers, fusion splicers, and stripping & crimping tools for splicing fibers, ideal for our splice-ready connectors. The splice protectors are compatible with fiber outer diameters of 900 µm. These sleeves are also available in lengths of 40 mm or 60 mm in packages of 25. The connectors sold here include a 60 mm splice protector sleeve which provides rigid support for the splice joint. ![]() Each connector includes 50 cm of SMF-28 Ultra single mode fiber, scissor cut on the spliceable end. Designed for the 1260 - 1625 nm wavelength range, our splice-ready connectors are available with one of three industry-standard connectors: FC/PC, FC/APC, or LC/PC. ![]() Thorlabs' splice-ready connectors, also commonly called splice-on connectors, offer a quick and easy method to repair broken or damaged optical fiber.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |